Diesel generator "Könner & Söhnen" KS 9200HDES-1/3 ATSR (EURO V)
|Max power (230V)
|Nominal power (230V)
|Max power (400V)
|Nominal power (400V)
|1 x CEE 230 V 32 A, 1 x CEE 400 V 16 A
|VTS 230/400 V, ATS output, Preheater function, 1-cylinder, Soundproof antivandal housing, Air cooled engine
Engines for diesel generators, as well as for gasoline, are manufactured under license DIMAX Int. GmbH and are marked with their own brand with the logo. In all models, the power reserve of the engine in relation to the alternator allows you to issue the declared voltage and maintain its stability in the full range of voltages. All engines are tested for long continuous operation, and then disassembled and examined for faults. Each engine and each generator has an individual serial number, which allows us to control the quality of production and service. The engines comply with all international and European standards of quality, efficiency, environmental friendliness (including the level of harmful emissions and noise).
Automatic transfer switch
|12 V DC
|from -10°C to +55°C; humidity: ⩽60%
|from -10°C to +70°C; humidity: ⩽60%
|AC1.5KV / 1min 1mA
|Maximum battery charging current from the built-in power supply, A
|Control cable length
|IP protection class
|Net dimensions (LxWxH)
|Gross dimensions (LxWxH)
The ATS (Automatic transfer switch) unit automatically starts the generator and transfers load to it when the main power supply is disconnected.
Gasoline and diesel generators with an electric starter are equipped with a universal 6-pin connector for an automatic transfer switch unit (ATS input). The ATS unit has a PLC that allows the automatic start/stop of the generator to be programmed in the event of a power outage and after its restoration.
PROGRAMMABLE LOGIC CONTROLLER OF THE ATS UNIT:
– Automatic/manual operation
– Programming of engine starting time after power outage
– Programming of engine warm-up time before connecting to consumer
– Setting of starter operation time
– Engine performance monitoring
– Battery charging when the generator is off
The KS ATS 4/63HD ATS unit is compatible with all Könner & Söhnen diesel generators with the abbreviation “ATSR” in the article number.
The ATS (Automatic Transfer Switch) unit automatically starts the generator and transfers load to it when the main power supply is disconnected and automatically stops the generator when the central power supply is restored.
Pre-start heating (PREHEATER)
Diesel generators series "HEAVY DUTY" are equipped with a pre-start heating function, which allows you to run the generator in the winter without much effort.
Assembled in PRC.
**In transient modes, the frequency of the generator can change in the short term, that is, during normal operation of the generator, the deviation of the frequency indicator is permissible. Depending on the type of generator, engine and operating mode, the frequency can be 49-54Hz
***Fuel consumption depends on many factors, such as load, fuel quality, season, altitude, technical condition of the generator.
KS CR-15M Cord reel
KS CR-25M Cord Reel
KS CRM-30M Cord Reel
KS EX1M-1S Socket adapter
KS EX1.5M-3S Socket adapter
KS EX3M-4S Socket adapter
KS B1A Automatic battery charger
KS Gloves L Gloves
Könner & Söhnen 10W-30 Universal motor oil
KS D-STAB 60 Diesel Stabilizer
KS D-ANTIGEL 20/60 Antigel
KS 6-9D S1 Air filter
KS 6-9D S2 Fuse
KS 6-9D S3 Fuel filter